Cross-stitch fabric size calculator

Enter your chart's stitch count to see the finished design size and how much Aida, evenweave or linen to cut, for every common fabric count.

Margin on each side
3 in (7.5 cm) is usual for framing. Use less for hoops or ornaments.

Cut your fabric at least 16 × 13.1 in

Design: 10 in (25.4 cm) × 7.1 in (18.1 cm)

Fabric with 3 in margins: 16 in (40.6 cm) × 13.1 in (33.4 cm)

On other fabrics

FabricDesign size (in)Fabric to cut (in)
11-count Aida12.7 × 9.118.7 × 15.1
14-count Aida10 × 7.116 × 13.1
16-count Aida8.8 × 6.314.8 × 12.3
18-count Aida7.8 × 5.613.8 × 11.6
20-count Aida7 × 513 × 11
25-count evenweave over 211.2 × 817.2 × 14
28-count evenweave over 210 × 7.116 × 13.1
32-count linen over 28.8 × 6.314.8 × 12.3
36-count linen over 27.8 × 5.613.8 × 11.6

How to use it

  • Enter the design's width and height in stitches. Most charts print this as a stitch count, such as 140w × 100h. If yours doesn't, count the squares along the top and down the side, using the bold lines that mark every 10.
  • Pick the fabric you'll stitch on. For one that isn't listed, choose Other count, then enter its count per inch and whether you'll stitch over 1 or 2 threads: 22-count Hardanger over 2 gives the same design size as 11-count Aida.
  • If a label gives the count per centimeter, multiply it by 2.54 for the count per inch: linen with 11 threads per cm is 28-count.
  • Enter the margin in inches or centimeters. The heading and the table give the fabric to cut in inches; the lines under the heading give centimeters as well.

How it works

Fabric count is how many stitches fit in one inch. On Aida you stitch over one square, so 14-count Aida gives 14 stitches per inch. On evenweave and linen you usually stitch over two threads, which halves the count: 28-count evenweave over two also gives 14 stitches per inch.

design size = stitches ÷ (fabric count ÷ threads stitched over)
fabric to cut = design size + 2 × margin

Example: 140 stitches on 14-count Aida make a design 10 in wide. Add 3 in on each side and the fabric to cut is 16 in wide.

Choosing a margin

  • Framing: 3 in (7.5 cm) or more on every side leaves room for the mount and for lacing or taping the fabric.
  • Hoop display: 2 in (5 cm) plus the depth of the hoop is usually enough.
  • Small finishes such as ornaments, cards and patches need only about 1 in (2.5 cm).
  • Working in a hoop or on scroll bars? Make sure the fabric is big enough to fit them comfortably.

Same chart, different fabric

A higher count makes a smaller, finer design from the same chart, and a lower count makes a bigger one with easier-to-see holes. The table in the results compares every common fabric so you can pick the size you want before you buy.

Last updated 2026-10-13. How these calculators are made.